Basler Electric BE1-BPR - Manual (Page 137)

9272000990 Rev J BE1-BPR Communications 6-9
PW Command
Purpose: Reads or changes password settings.
Syntax: PW [<#>[=<password>,<access(F/R/B)>]]
Reference: Section 4, Functional Description, Software Functional Description, Maintenance,
Programming A New Password
QUIT Command
Purpose: Exits the programming mode and returns the relay to on-line without saving any changes.
Syntax: QUIT
Reference: Section 4, Functional Description, Software Functional Description, Changing Parameters
Using Communication Ports
RESET Command
Purpose: Clears latched target data.
Syntax: RESET
Reference: Section 4, Functional Description, Software Functional Description, Target Data,
TARGETS Screen
SAVE Command
Purpose: Saves programming or settings changes, exits the programming mode, and returns the
relay to an on-line condition.
Syntax: SAVE
Reference: Section 4, Functional Description, Software Functional Description, Changing Parameters
Using Communication Ports
SHOWSET Command
Purpose: Returns a report of relay settings and logic equations.
Syntax: SHOWSET
Reference: Section 5, BESTLOGIC Programmable Logic, Miscellaneous Commands
SNAME Command
(Enhanced Relays Only)
Purpose: Reads or changes the station name and number for COMTRADE reports.
Syntax: SNAME [=<#>,<name>]
Reference: Section 4, Functional Description, Software Functional Description, Fault Log (Enhanced
Relays Only), Data Acquisition
STATUS Command
Purpose: Returns a report of inputs, outputs, and internal relay status.
Syntax: STATUS
Reference: Section 4, Functional Description, Software Functional Description, Relay Status
TARGET Command
Purpose: Reads input and output target information
Syntax: TARGET
Reference: Section 4, Functional Description, Software Functional Description, Target Data,
TARGETS Screen
TD Command
Purpose: Reads or changes timer delay settings.
Syntax: TD[x][=<delay>]]
Reference: Section 4, Functional Description, Software Functional Description, Relay Setup, Timers