Basler Electric BE1-BPR - Manual (Page 177)

9272000990 Rev J BE 1-BPR Relay Settings Rec ord C-3
LT6 = , ,
Virtual Output Logic Settings
Programmable VO w/ HW Outputs = Output Expression--AND *, OR +, NOT /, PARENTHESIS ( )
LOA =
LO1 =
LO2 =
LO3 =
LO4 =
LO5 =
Additional Programmable VO.
LO6 =
LO7 =
LO8 =
LO9 =
LO10 =
LO11 =
LO12 =
ACTIVE PROTECTION AND CONTROL LOGIC
Active Logic Scheme = Name
LOGIC =
POWER SYSTEM SETTINGS
Nominal Frequency = Hz, 50, 60
FREQ =
REAR COM PORT ADDRESS SETTINGS
Rear RS232/RS485 Port Address = ID,0=disabled,1-25
ID =
The following settings require protection access (PW1, PW2).
PROTECTION SETTINGS
Fault Detectors = Pick Up, Sec A , Moving Avg. Filter Window Time, Cycles
PU1 = ,
PU2 = ,
PU3 = ,
Timers = Time Delay, mSec
TD1 =
TD2 =
TD3 =
TD4 =
TD5 =
TD6 =