Daktronics OmniSport 2000 Timing Console - Manual (Page 108)

90 Diving Mode Operation, Menus & Settings
Configure Number of Judges
The correct number of judges is a critical part of scoring an event. To set the number of
judges, press [MENU]>[4]>[1]>[1] and select 2, 3, 5, 7 or 9 for the correct number of judges.
If 7 or 9 judges are selected, the LCD also prompts the user for the correct formula.
7.5 Operation During Event
Selecting the Order
At the beginning of a diving event, the correct Dive Order must be selected by pressing
[SELECT ORDER] and the correct letter key. Verify on the left LCD that the Diver # and
Round # are both set to “01”.
Entering Scores
Entering the scores is the most important part of a diving event. The following images
represent what the LCDs should look like if scores with nine judges were entered. The top
row of the left and middle LCDs displays the judges’ scores. The bottom row of those two
LCDs shows the dive number, position, degree of difficulty, total points awarded, and the
round. If a diver fails a dive or balks on a dive, AWARD is replaced with FAIL or BALK.
1 2 3 4 5 6 7 8 9 10
To start entering scores, first select a diver, dive, position and DD. The two methods to enter
scores are as follows:
When the Dive Order is pre-programmed (Section 7.4):
1. Verify on the center LCD that the correct dive, position, and DD is programmed.
2. If not, press [EDIT] and correct any mistakes.
3. Press [SCORE] and the left and middle LCDs will request the judges scores.
When the Dive Order is not pre-programmed:
1. Press [SCORE] and the left and middle LCDs will prompt the user to enter dive
and position. Use the numeric keypad to enter the three- or four-digit dive number
and the [A], [B], [C], and [D] keys for the position. Press [ENTER] to accept the
dive and position.
2. Use the number pad to enter the DD for the dive selected, then press [ENTER].
The left and middle LCDs then prompt the user for the judges’ scores.
Use the [0]-[10] scoring keys to fill in the judges’ scores. Press [FAIL] or [BALK] if they apply.
When the correct judges’ scores have been filled in, press [SCORE] to accept the awarded
score and advance to the next diver in that round. Repeat for each dive.
If that was the last diver for that round, press [→] to increment the round by one. Next, press
[DIVER
 ]>[1]>[ENTER]. Repeat the above steps until all dives and rounds are completed.
5 6 - - -
DI VE5152B DD3.2 - - - - RND
AWARD: 00.00 01 DI VER#05 RANK:--
TOTAL: 0:00