Daktronics OmniSport 2000 Timing Console - Manual (Page 123)

Diving Mode Operation, Menus & Settings 105
MENU-MAI N
5-TEST MENU
MENU-TEST
1-BATTERY
CUSTOM
PORT#- 18000*
MENU-NETWORK
7-NETWK PRO/MMR
MENU-NETWORK
6-MAC ADDRESS
o If the RTD will be sent to a Daktronics DVX/N
video display, press [1] followed by [ENTER].
The standard port number will vary by console
name as shown in the table at right.
o If the RTD will be sent to a Daktronics Galaxy
message center, press [2] followed by [ENTER].
The standard port number will always be “3002”.
 If a custom RTD port number is required, press [2].
Press the [0]-[9] keys to enter a new value and press
[ENTER]. To select a standard port number
instead, press [CLEAR] twice to exit the menu.
MAC Address
This menu allows the operator to verify the MAC address
of the console. The MAC Address cannot be edited. Press
any key to exit the menu.
Pro Software Enable
This menu allows the operator to enable network
communications to Pro Diving software.
Use [←][→] to toggle between ON/OFF and then press [ENTER] to continue.
7.17 Test Menu
The OmniSport 2000 timer is equipped with test features
that test battery level and the numeric scoreboard. The
following submenus explain how to use each of these tests.
Battery Test
This menu checks the battery power level.
The battery level will show as CHARGED or LOW. Press [ENTER] to exit the menu.
Name RTD Port #
OMNI1 21000
OMNI2 21001
OMNI3 21002
OMNI4 21003
From Main Menu – [5]>[1]
From Main Menu – [5]
BATTERY TEST
LEVEL= CHARGED BATTERY TEST
LEVEL= LOW
From Main Menu – [4]>[6]>[7]
MENU-NETWORK
NETWORK PRO:ON *
MAC ADDRESS
09:ec:03:01:06
From Main Menu – [4]>[6]>[6]