Daktronics OmniSport 2000 Timing Console - Manual (Page 200)

182 Water Polo Mode Operation, Menus & Settings
MENU-MAI N
4-TEST MENU
MENU-TEST
1-BATTERY
MENU-TEST
2-SCOREBOARD
SB TEST MENU
1-CYCLE ON/OFF
CUSTOM
PORT#- 18000*
MENU-NETWORK
6-MAC ADDRESS
o If the RTD will be sent to a Daktronics DVX/N video
display, press [1] followed by [ENTER]. The standard
port number will vary by console name as shown in
the table at right.
o If the RTD will be sent to a Daktronics Galaxy
message center, press [2] followed by [ENTER]. The
standard port number will always be “3002”.
 If a custom RTD port number is required, press [2].
Press the [0]-[9] keys to enter a new value and press
[ENTER]. To select a standard port number
instead, press [CLEAR] twice to exit the menu.
MAC Address
This menu allows the operator to verify the MAC address
of the console. The MAC Address cannot be edited. Press
any key to exit the menu.
13.16 Test Menu
The OmniSport 2000 timer is equipped with features that
test battery level and the numeric scoreboard. The
following submenus explain how to use each of these tests.
It is important to run through these tests before the game
begins to prevent problems from occurring during the game.
Battery Test
This menu checks the battery power level.
The battery level will show as CHARGED or LOW. Press [ENTER] to exit the menu.
Scoreboard Test
These menus check the numeric scoreboard drivers.
Cycle ON/OFF
This menu checks the signal to the scoreboard.
Name RTD Port #
OMNI1 21000
OMNI2 21001
OMNI3 21002
OMNI4 21003
From Main Menu – [4]
From Main Menu – [4]>[2]>[1]
From Main Menu – [4]>[1]
BATTERY TEST
LEVEL= CHARGED BATTERY TEST
LEVEL= LOW
DI SPLAY ALL ON
ENTER TO EXI T
MAC ADDRESS
09:ec:03:01:06
From Main Menu – [3]>[6]>[6]