Daktronics OmniSport 2000 Timing Console - Manual (Page 75)

Swimming Mode Menus & Settings 57
MENU-RTD/MATRI X
8-SHOW PLACE
MENU-RTD/MATRI X
9-RTD/OFFSET
MENU-SETUP
4-COMM PORTS
MENU-COMM PORTS
1-SCBD OUTPUTS
Use [←][→] to select NO to not show the start reaction time or YES to show the start reaction
time. Press [ENTER] to save.
Show Place
This menu determines whether or not to display place with
split times.
Use [←][→] to select YES or NO. If the console is set at YES, the scoreboard shows the
swimmer’s place and split time. Press [ENTER] to save.
RTD Offset
This menu will add an offset to the Real-Time Data (RTD)
output to the matrix display.
Use [↑][↓] to toggle through the RTD offset settings (0K, 5K, 10K or 15K). Each setting adds
5000 to the original item numbers, up to 15000. The default setting is 0K (no offset).
To save the setting, press [ENTER].
When to use this:
 Data from more than one pool/OmniSport 2000 is going to one display.
 If using a Daktronics M2, M3, or V-Link ® controlled display, this menu allows
multiple RTD input directly into the display.
5.9 Setup Comm Ports Menu
The following Comm Ports menus select the protocol used
for transmitting data to the display and communicating
with a results program.
Scoreboard Outputs
Select Scoreboard Outputs to assign a protocol to transmit
data from the J2 and J3 outputs on the console.
Use [←][→] to select Multidrop, Multiline, or Omega protocol, depending on the type of
display used, and then press [ENTER] to save. Multicast is reserved for future use.
From Main Menu – [4]>[4]>[1]
From Main Menu – [4]>[3]>[2]>[8]
From Main Menu – [4]>[3]>[2]>[9]
From Main Menu – [4]>[4]
SHOW PLACE
FOR SPLI TS= NO * SHOW PLACE
FOR SPLI TS= YES*
MENU-RTD/MATRI X
RTD OFFSET: 5K*
MENU-COMM PORTS
SCBD: MULTI DROP*