Daktronics OmniSport 2000 Timing Console - Manual (Page 274)

222 Menu Navigation Shortcuts
4) SETUP MENU
4-1) TIMER configures the timer settings
4-1-1) BEEPER VOLUME sets the volume of the internal beeper
4-2) SCOREBOARD configures the scoreboard settings
4-2-1) NUMERIC sets output data for numeric scoreboards
4-2-1-1) # OF LINES sets the number of lines on the scoreboard
4-2-2) RTD/ MATRIX sets output data for matrix displays
4-2-2-1) RTD OFFSET sets how data is sent to the display with 2+ consoles or pools
4-3) COMM PORTS configures the communication ports
4-3-1) SCBD OUTPUTS sets the J2/J3 protocol (MULTIDROP, MULTILINE, or OMEGA)
4-3-2) RTD PORT sets the J5 protocol (RTD or CTS)
4-3-3) RESULTS PORT sets the J6 protocol (OMNI 2000, OMNI 6000, or CTS)
4-4) PRINTER configures printouts and the printer
4-4-1) INTENSITY sets printer intensity (contrast)
4-5) TIME OF DAY sets the day/month/year and hours/minutes/seconds
4-6) NETWORK configures the ETHERNET port
4-6-1) NETWORK ENABLE enables/disables the ETHERNET port (ON or OFF)
4-6-2) IP ADDRESS sets the IP Address
4-6-3) SUBNET MASK sets the Subnet Mask
4-6-4) GATEWAY ADDRES sets the Gateway Address
4-6-5) RTD PORT # sets the Real-Time Data port number
4-6-6) MAC ADDRESS
displays the console’s MAC Address
5) TEST MENU
5-1) BATTERY checks battery power level
5-2) SCOREBOARD allows testing of the scoreboard
5-2-1) CYCLE ON/OFF sends an all ON signal to the scoreboard in 3 second intervals
5-2-2) DRIVER ADDRESS displays the driver address(es)
5-2-3) DIGIT NUMBER displays digit numbers
4-Water Polo Menu Navigation
1) SCBD MENU
1-1) SCBD ON/OFF clears the display
1-2) DIMMING sets the dimming (brightness) level of the display
1-3) TIME OF DAY displays the Time-of-Day and time format
2) PRINT MENU
2-1) SETTINGS prints out all configurations entered in the Setup Menu
2-2) PAPER FEED advances the printer paper one line
3) SETUP MENU
3-1) TIMER configures the game settings
3-1-1) SET TIMES sets the times used while playing the game
3-1-1-1) PERIOD TIME sets the timing length of the period
3-1-1-2) OVER TIME sets the timing length of the overtime period
3-1-1-3) REST TIME sets the timing length of the rest periods
3-1-1-4) WARNING TIME sets the timing length of warning times
3-1-1-5) SHOT TIME sets the timing length of the shot time
3-1-1-6) TIMEOUT TIME sets the timing length of timeouts
3-1-1-7) PENALTY TIME sets the timing length of the penalties
3-1-2) AUTO SEQUENCE sets the automatic clock run
3-1-3) SHOT=0 CONTROL sets if the shot clock = 0 will stop the main clock
3-1-4) PENALTIES sets the maximum amount of penalties and reset of shot clock
3-1-5) TIMEOUTS sets the maximum number of timeouts
3-1-6) HORN CONTROL selects how the game clock and shot clock horns operate
3-1-7) BEEPER VOLUME sets the volume of the internal beeper