Start, Stop, Reset – Daktronics OmniSport 2000 Timing Console User Manual

Page 187: Shot time keys, Set time, Recall shot time

Advertising
background image

Water Polo Mode Operation, Menus & Settings

169

Press [SET TIME

] three times to set the Rest 1 time—typically the rest period between

quarters 1 and 2 or quarters 3 and 4. Press [ENTER] and use the numeric keypad to change
the default Rest 1 time, then press [ENTER]. This sets the new Rest 1 time in the main clock
and the default time in the console’s stored memory.

Press [SET TIME

] four times to set the Rest 2 time—typically the rest period for half time

and before overtime, if the match goes into overtime. Press [ENTER] and use the numeric
keypad to change the default Rest 2 time, then press [ENTER]. This sets the new Rest 2 time
in the main clock and the default time in the console’s stored memory.

Press [SET TIME

] five times to set the default overtime. Press [ENTER] and use the

numeric keypad to input the desired default overtime and then press [ENTER]. This sets
the main clock to the new overtime and it changes the default overtime in the console’s
stored memory.

Start

Press [START] to start the clock counting.

Stop

Press [STOP] to stop the clock.

Reset

Press [RESET] followed by [ENTER] to set the main clock to the default period time value.
To cancel resetting the clock, press [CLEAR]. The clock must be stopped otherwise the
[RESET] key will be ignored.

Shot Time Keys

The keys in the SHOT TIME section control the shot clock.

Set Time

Press [SET TIME

] to set a specific time for the shot clock. One use would be if an official

wanted to put 5 seconds back onto the shot clock.

Reset

Press [RESET] to reset the shot clock time to the default value. [RESET] can be pressed while
the clock is running or stopped.

Recall Shot Time

Press [RECALL SHOT TIME

] to set the shot clock back to the time that was on the clock

before [RESET] was pressed. This is helpful if [RESET] was accidentally pressed, or if a
turnover was nullified by an official’s ruling.

Start

Press [START] to start the shot clock counting.

Stop

Press [STOP] to stop the shot clock.

Advertising
This manual is related to the following products: