Daktronics OmniSport 2000 Timing Console - Manual (Page 73)

Swimming Mode Menus & Settings 55
MENU-SCOREBOARD
2-RTD/MATRI X
MENU-RTD/MATRI X
1-# OF LI NES
MENU-RTD/MATRI X
2-SPLT HOLD TI ME
MENU-RTD/MATRI X
3-FI N PAGE TI ME
Use [←][→] to select NO to not show the start reaction time or YES to show the start reaction
time. Press [ENTER] to save.
5.8 Setup RTD/Matrix Scoreboard Menu
Number of Lines
This menu sets the # of Lines of lane data being sent to the
matrix scoreboard. If the number of lanes in the pool is
greater than the value set, the timer will automatically page
the information in place order. The default is 10.
Press the [0]-[9] keys to enter the number of lines appropriate to the facility’s display and
then press [ENTER] to save.
Split Hold Time
Select Splt Hold Time to configure how long the split times
remain on display. The Split Hold Time can be set from 1-99
seconds. The default time is 15 seconds.
Press the [0]-[9] keys to enter the number of seconds and then press [ENTER] to save.
Note: For splits—only the first place split will display and hold for the amount of time set
in the Split Hold Time menu. Finish Times will page according to the amount of time set in
the Finish Page Time menu.
Finish Page Time
This menu configures how long (0 to 99 seconds) each page
of the Finish Times will hold on the display.
Press the [0]-[9] keys to enter the appropriate length of time the finish time will appear on the
display and then press [ENTER] to save. The default time is 5 seconds.
From Main Menu – [4]>[3]>[2]
From Main Menu – [4]>[3]>[2]>[1]
From Main Menu – [4]>[3]>[2]>[2]
From Main Menu – [4]>[3]>[2]>[3]
# OF LI NES
LI NES= ^8
SPLI T HOLD TI ME
TI ME= ^5*
FI NI SH PAGE TI ME
TI ME: ^5*