Beeper volume – Daktronics OmniSport 2000 Timing Console User Manual

Page 70

Advertising
background image

52

Swimming Mode Menus & Settings

MENU-TI MER
8-BEEPER VOLUME

OMEGA PLATFORM tells the timer that an Omega platform is being used. The console will
use these inputs to print and display start reaction times for races that start on the block and
relay exchanges for events configured as relays.

Use [←][→] to toggle the setting between NONE, BTN/DAKTRONICS or OMEGA PLATFORM
and then press [ENTER] to save. If the console was set to NONE, this function is completed.
If either of the other two settings were selected, the console will prompt the operator for
additional input information.

Since relay exchanges are only used during the splits, and back-up buttons are only
needed on the final time, the timer uses the same inputs for platforms as it does for buttons.
The platform can be plugged into Button 1, 2 or 3 input on the lane module or deck plate.
Typically Button 3 input is used.




Use [←][→] to toggle the setting between 1, 2 and 3 and then press [ENTER] to save and
advance to the next setting.

The relay take-off arm time is the amount of time that the console will look for an input from
the platform, after it has received a touchpad. This is used to filter out any garbage data in
case of teammates inadvertently bumping or slapping the top of the platform. The arming
time can be set from 0.1–1.5 seconds. A setting of 0.8 seconds works the best.




Press the [0]-[9] keys to enter the time and then press [ENTER] to save.

Note: Even with a correct arm time setting, it is very important that no one except the
competitor in the event touches the platform during relay events. The console does not
know the difference between the correct athlete, a teammate, or an official leaning
against the block.

Beeper Volume

This menu is for setting the internal beeper volume when
keys are pressed.





Use [↑][↓] or the [0]-[7] keys to set the volume level, with 7 being the loudest setting.
Press [ENTER] to save.



RELAY TAKE-OFF
I NPUT USED: 3*

RELAY TAKE-OFF
ARM TI ME:0.8sec*

MENU-TI MER
BEEPER VOLUME:5

From Main Menu

– [4]>[2]>[8]

Advertising
This manual is related to the following products: