Daktronics OmniSport 2000 Timing Console - Manual (Page 79)

Swimming Mode Menus & Settings 61
MENU-NETWORK
2-I P ADDRESS
I P ADDR- OMNI 1
192*168. 0. 55
MENU-NETWORK
3-SUBNET MASK
MENU-NETWORK
4-GATEWAY ADDRES
Use [←][→] to toggle between ON/OFF and then press [ENTER] to save.
Note: If this setting is set to OFF, all of the menus below will be disabled.
IP Address
This menu allows the operator to set or verify the IP address
of the console. The default setting is shown below.
In most cases, the standard IP address should be selected.
Press [1] followed by [ENTER] and the display will verify
the console’s IP address. The standard IP address varies by
console name as shown in the table at right.
If a custom IP address is required, such as for connecting to
a non-Daktronics network, press [2] followed by [ENTER].
Press the [0]-[9] keys to enter a new value for each group of
numbers and press [ENTER] after every group. To select a
standard address instead, press [CLEAR] twice to exit the menu.
Note: Once the console has been successfully connected to a network, it must be
disconnected from the network in order to change the IP address settings.
Subnet Mask
The subnet mask may only be edited if the IP address is set
to custom. The default setting is shown below.
Press the [0]-[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.
Gateway Address
The gateway address may only be edited if the IP address
is set to custom. The default setting is shown below.
Press the [0]-[9] keys to enter a new value for each group of numbers and press [ENTER]
after every group. If no change is needed, press [CLEAR] twice to exit the menu.
Name IP Address
OMNI1 192.168. 0. 55
OMNI2 192.168. 0. 56
OMNI3 192.168. 0. 57
OMNI4 192.168. 0. 58
1-STD* 2-CUST
192.168. 0. 55
From Main Menu – [4]>[7]>[2]
SUBNET MASK
255*255.255. 0
From Main Menu – [4]>[7]>[3]
GATEWAY ADDRESS
192.168. 0. 1
From Main Menu – [4]>[7]>[4]