Daktronics OmniSport 2000 Timing Console - Manual (Page 19)

Introduction 1
Section 1: Introduction
1.1 Manual Contents for Version 13.07.08 and Beyond
This manual explains the operation, installation, maintenance, and troubleshooting of the
OmniSport
® 2000 series timing system —console Version 13.07.08 and beyond. (Version
numbers refer to the date the version was released—13.07.08 was released on July 8, 2013.)
For additional information regarding the service of this system, refer to the telephone
numbers listed in Section 16.
Figure 1 illustrates a Daktronics drawing label.
The drawing number is located in the lower-right
corner of a drawing. In the example, the drawing
would be referred to as Drawing A-69945.
Please list the model and serial number, and the date received in the blanks provided on the
front page of this manual. When calling Daktronics customer service, have this information
available to ensure the request is serviced as quickly as possible.
Section 16 contains the Daktronics Exchange Policy plus the Repair & Return Program.
Refer to these instructions if any timing components need replacing or repairing.
1.2 Timer Overview
Reference Drawing:
Connector Designations, OmniSport 2000 ............................................ Drawing A-154282
Daktronics OmniSport 2000 series controller is a state-of-the-art timing and scoring system.
It has the capability to run a variety of timing events. The timer’s liquid crystal display (LCD)
guides the user through the operation of the system. Refer to Drawing A-154282 for an
overview of the OmniSport 2000 timer’s layout and connectors.
Safety First
As a safety feature, this product has a three-wire, ground-type plug equipped with a third
(grounding) pin. This plug only fits into a grounding-type power outlet. If unable to insert
the plug into the outlet, contact a qualified electrician to replace the obsolete outlet.
Battery
An internal battery allows the timer to continue operation for approximately 10 minutes in the
event of a power failure.
CAUTION! RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Opening Timer Packages
When opening the timer packages, inspect for shipping damage. Verify that all equipment is
included and itemized on the packing slip. Immediately report any deficiencies to
Daktronics, and save all packing materials for shipping if warranty repair or exchange is
necessary. Record the model and serial number along with the date received on the front
cover of this manual.
Figure 1: Daktronics Drawing Label