Super Systems 20PQ - Manual (Page 108)

104
INDICATORS
°C Lit when process variable is in Centigrade degrees.
°F Lit when process variable is in Fahrenheit degrees.
ST Flashing when the first step of SMART algorithm is
activated.
Lit when the second step of SMART algorithm is activated.
RUN Lit when the program is running.
Flashing when the time-out of the RUN function is spent
(when RUN is flashing, by releasing the RUN pushbutton,
the program will start).
HLD Lit when program is stopped (HOLD mode).
Flashing when the time-out of the HOLD function is spent
(when HOLD is flashing, by releasing the RUN pushbutton,
the program will restart).
PRG Lit when the instrument is in programmer mode.
Flashing when the program selected for editing or test is a
new program.
% Lit when the lower display shows the control output value.
SEG Lit when a program is running.
Flashing when a new segment has been added to an
already existing program.
Ú Lit when the segment in progress is a ramp up.
Flashing slowly when the FAST FORWARD is in progress
and it is moving on a ramp up.
Flashing fast when the FAST BACKWARD is in progress
and it is moving on a ramp up.
Ù Lit when the segment in progress is a soak.
Flashing slowly when the FAST FORWARD is in progress
and it is moving on a soak.
Flashing fast when the FAST BACKWARD is in progress
and it is moving on a soak.
Ø Lit when the segment in progress is a ramp down.
Flashing slowly when the FAST FORWARD is in progress
and it is moving on a ramp down.
Flashing fast when the FAST BACKWARD is in progress
and it is moving on a ramp down.
MAN Lit when device is in manual mode.
REM Lit when device is controlled by serial link.
RSP Lit when Set point trim is used (auxiliary linear input).
SPX Lit when a temporary set point, from serial link, is used
during controller mode.
1 Lit when OUT 1 is used as control output and it is in ON
condition or when Event 1 is activated or when alarm 1 is
in alarm state and acknowledged.
Flashes when alarm 1 is in alarm state and it is not
acknowledged.
2 Lit when OUT 2 is used as control output and it is in ON
condition or when Event 2 is activated or when alarm 2 is
in alarm state and acknowledged.
XKP-1-C2.p65 10/30/01, 9:37 AM 104