Super Systems 20PQ - Manual (Page 61)

57
CnF. 5
NOTE: for ABORT function only, the input
status must be maintained for more than 3
seconds.
Pr.SL = Input contact used for program selection (for
more details see NOTE 2) of the "d1.Fn"
("Logic input 1 function" [C.H01]) parameter).
NOTE: See also all NOTES of the "d1.Fn" ("Logic input 1
function" [C.H01]) parameter.
- Logic input IN 1 - contact status - [C.H08]
This parameter will be available only when "I1.Fn" [C.H07] is
different from “nonE”.
Range: CLSd = The input is at logic level “1” when contact is
closed.
When "I1.Fn" [C.H07] is equal to “ru.St”, the
instrument toggles from one status to the other
one when the transition from contact open to
contact close is detected.
OPEn = The input is at logic level “1” when contact is
open.
When "I1.Fn" [C.H07] is equal to “ru.St”, the
instrument toggles from one status to the other
one when the transition from contact close to
contact open is detected.
The steps C.H07 and C.H08 can be repeated for all the
fitted logic input (from IN 2 to IN 8).
- Event 1 function - [C.H09]
This parameter will be available only when OUT 1 is configured
as event annunciator ("O1.Fn" [C.E01] is equal to “Eun.1”).
Range: nonE = Event not used (for Events from 10 to 19 only)
brk.E = Break event
TIñ.E = Timer event
At the power ON, after a power supply failure,
the timer event continues from the same point it
was prior to the power failure.
End.c = End of cycle annunciator.
At the end of every cycle, the instrument forces
the output programmed as "end of cycle
annunciator" in ON status for a time equal to
the value assigned to "tE.cY" [C.H11]
parameter.
End.P = End of profile annunciator.
At the end of the profile, the instrument forces
XKP-1-C2.p65 10/30/01, 9:37 AM 57