Super Systems 20PQ - Manual (Page 137)

133
INDICATORS function during controller mode
°C Lit when process variable is in Celsius degrees.
°F Lit when process variable is in Fahrenheit degrees.
ST Flashing when the first step of SMART algorithm is
activated.
Lit when the second step of SMART algorithm is activated.
% Lit when the lower display shows the control output value.
MAN Lit when device is in manual mode.
REM Lit when device is controlled by serial link.
RSP Lit when Set point trim (auxiliary input) is used.
SPX Lit when a temporary set point, from serial link, is used.
1
Lit when OUT 1 is used as control output and it is in ON
condition or when Event 1 is activated or when alarm 1 is
in alarm state and acknowledged.
Flashes when alarm 1 is in alarm state and it is not
acknowledged.
2 Lit when OUT 2 is used as control output and it is in ON
condition or when Event 2 is activated or when alarm 2 is
in alarm state and acknowledged.
Flashes when alarm 2 is in alarm state and it is not
acknowledged.
3 Lit when OUT 3 is used as control output and it is in ON
condition or when servomotor output increases or when
Event 3 is activated or when alarm 3 is in alarm state and
acknowledged.
Flashes when alarm 3 is in alarm state and it is not
acknowledged.
4 Lit when OUT 4 is used as control output and it is in ON
condition or when servomotor output decreases or when
Event 4 is activated or when alarm 4 is in alarm state and
acknowledged.
Flashes when alarm 4 is in alarm state and it is not
acknowledged.
DIRECT ACCESS TO THE SET POINT
When the device works as controller in AUTO mode and it is in
“Normal Display Mode”, it is possible to access directly to the set
point modification.
Pushing
s or t for more than 2 s, the set point will begin
changing.
The new set point value becomes operative since no push-
button has been depressed at the end of 2 s time out.
The direct access to the set point is disabled if the run time
group 1 is software protected.
XKP-1-C2.p65 10/30/01, 9:37 AM 133