Super Systems 20PQ - Manual (Page 117)

113
Gr. P
GENERAL NOTES ABOUT PROGRAM EDITING
This instrument allows to create up to 90 simple programs with a
free number of segments for each program.
The instrument total capability is equal to 200 segments.
Each simple program coudn't encompass more than 99
segments.
For each segment it is possible to define the status of the
outputs programmed as Break event output.
To each program, instead, it is possible to associate up to 14
timer event each one of them is composed of 5 periods.
The time count and the program start together and the status of
the output is equal to:
- ON during the first period,
- OFF during the second period,
- ON during the third period,
- OFF during fourth period,
- ON during the fifth period,
- OFF at the end of the fifth (and last) period.
Furthermore, each program can be completed by the "End of
cycle" and the "End of profile" indication.
It is also possible to create up to 9 linked programs.
A linked program is a sequence of up to 9 simple programs.
EDIT MODE
By the EDIT mode it is possible to create, modify or delete all
the program types.
The EDIT mode is accessible when the instrument is in
programmer mode.
During edit mode the instrument performs all the standard
control functions.
When no program is running, no time out is applied to the EDIT
mode.
If a program editing is made when the instrument is running a
program, a 10 or 30 seconds time out (see [C.I10]) is applied to
the EDIT mode.
During the EDIT mode, all the informations and notes about
"Control parameters protection" (see page 69) and "Control
parameters modification" (see pag 69) are still valid.
When it is desired to enter in EDIT mode, select the Group P
and push the FUNC pushbutton.
Follows the complete set of EDIT mode parameters
During the EDIT mode, the upper display shows the selected
parameter group, the lower display shows the mnemonic code
of the selected parameter while the central display shows the
value or status assigned to the selected parameter.
XKP-1-C2.p65 10/30/01, 9:37 AM 113