Super Systems 20PQ - Manual (Page 136)

132
0.0 % to 99.9 % or a value within the scale configured by
“ñC.E.L” [C.F09] and “ñC.E.H” [C.F10] when a scaled readout
is applied to the main output.
The instrument will show “ . “ when the control output is
> 100.0 %.
NOTE: When the MAIN output is a servomotor type, the
instrument shows, for this output, the feedback position (in the
range from -19.0 % to 99.9 %) instead of the output in
percent.
f) Push FUNC push-button again, the lower display will show
"S." followed by the SECONDARY control output value in the
range 0.0 % to 99.9 % or within the scale configured by
“SC.E.L” [C.F15] and “SC.E.H” [C.F16].
The instrument will show “ . “ when the control output is
> 100.0 %.
NOTE: When the secondary output is a servomotor type, the
instrument shows, for this output, the feedback position (in the
range from -19.0 % to 99.9 %) instead of the output in
percent.
g) Push FUNC push-button again, the lower display will show
the value of the auxiliary input, if configured.
- Pushing FUNC push-button again, the display will come back
to the control output value indication.
All the seven types of visualization are not bound to a time out
unless OFD (output failure detection) is in the not acknowledged
alarm condition.
In this situation, the instrument forces the indication described at
point d) and, if a different indication is required, it restores this
indication after time out (see “t.out” [C.I10]).
NOTES:
1) The previous informations will be displayed only if the related
function has been previously configured.
2) After parameter modification or monitoring, the instrument
comes back to the "normal display mode" with, on the lower
display, the indication previously selected.
XKP-1-C2.p65 10/30/01, 9:37 AM 132