Super Systems 20PQ - Manual (Page 156)

A. 2
B.4) Push the FUNC pushbutton.
The middle display will show:
and then it will show:
The default parameter loading procedure of all run time
parameters is ended.
The following is a list of the default run time parameters loaded
during the above procedure:
Run time group 2 [r.bxx]
PARAMETER DEFAULT VALUE
SP = Set point low limit ("rL" [r.E12])
Pr.St = nonE
St.dY = ñon
St.tñ = 0.00 h.mm
Run time group 3 [r.Cxx]
PARAMETER DEFAULT VALUE
ñ.rSt = OFF
AL1 = Initial range value (for process alarm)
= 0 (for deviation alarm)
= 0.0 (for control output alarm)
bA1.L = 0
bA1.h = 0
AL2 = Initial range value (for process alarm)
= 0 (for deviation alarm)
= 0.0 (for control output alarm)
bA2.L = 0
bA2.h = 0
AL3 = Initial range value (for process alarm)
= 0 (for deviation alarm)
= 0.0 (for control output alarm)
bA3.L = 0
bA3.h = 0
AL4 = Initial range value (for process alarm)
= 0 (for deviation alarm)
= 0.0 (for control output alarm)
bA4.L = 0
bA4.h = 0
A.L.Fd = Initial scale value
A.H.Fd = Final scale value
HSA1 = 1
HSA2 = 1
HSA3 = 1
HSA4 = 1
XkP-A-C2.P65 10/30/01, 9:44 AM 2