Super Systems 20PQ - Manual (Page 127)

123
3) select the final set point of the segment x+1:
4) push "RUN" + "
s" pushbuttons; the display will show the final
set point of the new segment with the "End" indication.
NOTE: modify this value before to push the FUNC
pushbutton otherwise all the following segments will be
deleted.
5) set the remaining parameters of the new segment;
It is now possible to exit from edit mode.
For segment addition, the same notes described for segment
modification are valid.
HOW TO DELETE A SEGMENT IN AN EXISTING SIMPLE
PROGRAM
When it is desired to delete a segment at the end of a program,
it is sufficent to:
1) select the Group P (EDIT mode);
2) select the desired program;
3) reach the last programmed segment;
4) when the instrument displays the final set point of the last
segment, select the "End" indication and push the FUNC
pushbutton.
It is now possible to exit from edit mode.
When it is desired to delete the segment x, proceed as follows:
1) select the Group P (EDIT mode);
2) select the desired program;
3) select the final set point of the segment x;
4) push "RUN" + "
t" pushbuttons; the display will show the final
set point of the x + 1 segment.
It is now possible to exit from edit mode.
For segment deleting, the same notes described for segment
modification are valid.
HOW TO DELETE AN EXISTING SIMPLE PROGRAM
When it is desired to delete a simple program, it is sufficent to:
1) select the Group P (EDIT mode);
2) select the desired program;
3) reach the first programmed segment;
4) when the instrument displays the final set point of the first
segment, select the "End" indication and push the FUNC
pushbutton. The display will show the number of the selected
program with the PRG LED flashing.
NOTE: it is not possible do delete a simple program used in
one or more linked programs.
It is now possible to exit from edit mode.
XKP-1-C2.p65 10/30/01, 9:37 AM 123