ACTi NVR 2.3 Enterprise V2.3.04.07 User Manual
Page 98
NVR 2.3 (V2.3.05.11) User’s Manual
Fig. 80 Active Monitor - PTZ Panel - Mouse PTZ
4. Tour: Select PTZ Preset Tour from this drop down list. You can setup the Preset tour for
each camera in Camera Setup.
5. Control Pad: Click on this wheel to control PTZ movements.
6. Zoom In/Out: If the camera has controllable zoom, this will zoom the lens in or out.
7. Focus In/Out: If the camera has controllable focus, this will shift the focus of the camera.
Please note that if you use manual controlled focus, then auto-focus has to be disabled on
the camera side via web configurator. Otherwise the camera will return to the auto-focus
value once you finished the focus command.
8. Iris In/Out: If the camera has controllable iris, this will modify Iris level.
9. Pan: Set the Pan speed of the control pad.
10. Tilt: Set the Tilt speed of the control pad.
11. Goto: Go to a preset point. Just select the target from the drop down list. You must first
setup the preset point through NVR to use this.
12. Action: If you have special PTZ commands entered here, you may select from the drop
down list to issue that particular command.