RIGOL DSG3000 Series - Manual (Page 100)

RIGOL Chapter 2 Command System
2-80 DSG3000 Programming Guide
[:SOURce]:PULM:WIDTh
Syntax [:SOURce]:PULM:WIDTh <value>
[:SOURce]:PULM:WIDTh?
Description Set the width of the pulse modulating signal.
Query the width of the pulse modulating signal.
Parameter Name Type Range Default
<value> Real 10ns to 170s-10ns 500us
Explanation  When <value> is set in "Number" form, the default unit is s. Besides, <value>
can also be set in "Number + Unit" form, for example, 2000ms.
 The default unit of the return value is s.
 When the modulation source is set to "Int", you can use this command to set
the width of single pulse if the pulse type is set to "Single" and you can use this
command to set the width of #1 pulse if the pulse type is set to "Double".
Otherwise, this command is invalid.
 After setting the pulse width, you can use the up/down direction keys or knob
to modify the pulse width at the current step. At this point, you can query or set
the current step using the [:SOURce]:PULM:WIDTh:STEP command.
 The single pulse width is limited by the minimum pulse width and pulse period
and the three fulfill the following relations.
Pulse Width ≥ Minimum Pulse Width
Pulse Width ≤ Pulse Period – 10ns
 The width of #1 pulse of double pulse is limited by the minimum pulse width
and delay.
Pulse Width ≥ Minimum Pulse Width
Pulse Width ≤ Delay – 10 ns
Return Format The query returns the width of the pulse modulating signal, for example, 2.
Example :PULM:WIDT 2
:PULM:WIDT?
Related
Commands
[:SOURce]:PULM
[:SOURce]:PULM:MODE
[:SOURce]:PULM:PERiod
[:SOURce]:PULM:SOURce
[:SOURce]:PULM:WIDTh:STEP