RIGOL DSG3000 Series - Manual (Page 105)

Chapter 2 Command System RIGOL
DSG3000 Programming Guide 2-85
[:SOURce]:SWEep:LIST:INITialize:FSTep
Syntax [:SOURce]:SWEep:LIST:INITialize:FSTep
Description Recalculate the data point set in the current step sweep to generate a new sweep list.
Explanation  In the new sweep list, "ListNum" depends on the "Points" of the step sweep.
 "Frequency" depends on the "Start Frequency" and "Stop Frequency" of the step
sweep.
 "Amplitude" depends on the "start Level" and "Stop Level" of the step sweep.
 "Time" depends on the "Dwell Time" of the step sweep.
Related
Commands
[:SOURce]:SWEep:STEP:DWELl
[:SOURce]:SWEep:STEP:POINts
[:SOURce]:SWEep:STEP:STARt:FREQuency
[:SOURce]:SWEep:STEP:STARt:LEVel
[:SOURce]:SWEep:STEP:STOP:FREQuency
[:SOURce]:SWEep:STEP:STOP:LEVel
[:SOURce]:SWEep:LIST:INITialize:PRESet
Syntax [:SOURce]:SWEep:LIST:INITialize:PRESet
Description Reset the sweep list to factory setting.
Explanation  After resetting the sweep list using this command, the sweep list only contains
one frequency point (6GHz) and level point (-140dBm).
 You can use the [:SOURce]:SWEep:LIST:ADDList and
[:SOURce]:SWEep:LIST:DELete commands to re-edit the current sweep list.
Related
Commands
[:SOURce]:SWEep:LIST:ADDList
[:SOURce]:SWEep:LIST:DELete