RIGOL DSG3000 Series - Manual (Page 98)

RIGOL Chapter 2 Command System
2-78 DSG3000 Programming Guide
[:SOURce]:PULM:TRIGger:EXTernal:SLOPe
Syntax [:SOURce]:PULM:TRIGger:EXTernal:SLOPe POSitive|NEGative
[:SOURce]:PULM:TRIGger:EXTernal:SLOPe?
Description Set the slope of the valid edge of the external trigger pulse.
Query the slope of the valid edge of the external trigger pulse.
Parameter Name Type Range Default
POSitive|NEGative Discrete POSitive|NEGative POSitive
Explanation  When the trigger mode of pulse modulation is set to "Ext Trig", the RF signal
generator receives the external trigger signal input from the [PULSE
IN/OUT] connector at the rear panel. At this point, you can use this
command to set the trigger edge of the external trigger signal.
 The parameter POSitive|NEGative can set the slope of the valid edge of the
external trigger pulse to "Pos" or "Neg".
 This command is invalid when "Ext" modulation source is selected.
Return Format The query returns POSITIVE or NEGATIVE.
Example :PULM:TRIG:EXT:SLOP NEG
:PULM:TRIG:EXT:SLOP?
Related
Commands
[:SOURce]:PULM:TRIGger:MODE
[:SOURce]:PULM:SOURce