RIGOL DSG3000 Series - Manual (Page 90)

RIGOL Chapter 2 Command System
2-70 DSG3000 Programming Guide
[:SOURce]:PULM:OUT:STATe
Syntax [:SOURce]:PULM:OUT:STATe ON|OFF|0|1
[:SOURce]:PULM:OUT:STATe?
Description Turn on or off the pulse output switch.
Query the state of the pulse output switch.
Parameter Name Type Range Default
ON|OFF|0|1 Bool ON|OFF|0|1 OFF
Explanation  ON|1: turn on the pulse output switch. At this point, the RF signal generator
can output the pulse signal generated by the internal pulse generator via the
[PULSE IN/OUT] connector at the rear panel. Note that this output signal is
related to the "Mode" setting.
 OFF|0: turn off the pulse output switch.
 This command is invalid when "Ext" modulation source is selected.
Return Format The query returns 1 or 0.
Example :PULM:OUT:STAT ON /*Turn on the pulse output switch*/
:PULM:OUT:STAT? /*The query returns 1*/
Related
Commands
[:SOURce]:PULM:MODE
[:SOURce]:PULM:SOURce