RIGOL DSG3000 Series - Manual (Page 139)

Chapter 2 Command System RIGOL
DSG3000 Programming Guide 2-119
:SYSTem Commands
The :SYSTem commands are used to set a series of parameters relating to the system and the settings of
these parameters do not affect the output signal of the RF signal generator.
Command List:
 :SYSTem:BRIGhtness
 :SYSTem:CLEar
 :SYSTem:COMMunication:GPIB[:SELF]:ADDRess
 :SYSTem:COMMunication:INTerface
 :SYSTem:COMMunication:LAN:DHCP
 :SYSTem:COMMunication:LAN:IP:ADDress
 :SYSTem:COMMunication:LAN:IP:AUTO
 :SYSTem:COMMunication:LAN:IP:GATeway
 :SYSTem:COMMunication:LAN:IP:MANual
 :SYSTem:COMMunication:LAN:IP:SET
 :SYSTem:COMMunication:LAN:IP:SUBnet:MASK
 :SYSTem:COMMunication:LAN:RESet
 :SYSTem:COMMunication:LAN[:SELF]:PREFerred
 :SYSTem:DATE
 :SYSTem:DISPlay:UPDate[:STATe]
 :SYSTem:FSWitch:STATe
 :SYSTem:LANGuage
 :SYSTem:LKEY
 :SYSTem:POWer:ON:TYPE
 :SYSTem:PRESet
 :SYSTem:PRESet:TYPE
 :SYSTem:PRESet:SAVE
 :SYSTem:TIME