RIGOL DSG3000 Series - Manual (Page 48)

RIGOL Chapter 2 Command System
2-28 DSG3000 Programming Guide
[:SOURce]:FREQuency:OFFSet:STEP
Syntax [:SOURce]:FREQuency:OFFSet:STEP <value>
[:SOURce]:FREQuency:OFFSet:STEP?
Description Set the RF frequency offset step.
Query the RF frequency offset step.
Parameter Name Type Range Default
<value> Real 10mHz to 10GHz 100MHz
Explanation  When <value> is set in "Number" form, the default unit is Hz, for example,
5000. In addition, <value> can also be set in "Number + Unit" form, for
example, 5kHz.
 The default unit of the return value is Hz.
 After the frequency offset step is set, you can use the up/down direction keys
or knob to modify the frequency offset at the current step. At this point, you
can query or set the frequency offset using the [:SOURce]:FREQuency:OFFSet
command.
Return Format The query returns the RF frequency offset step, for example, 5000.
Example :FREQ:OFFS:STEP 5kHz
:FREQ:OFFS:STEP?
Related
Command
[:SOURce]:FREQuency:OFFSet
[:SOURce]:FREQuency:STEP
Syntax [:SOURce]:FREQuency:STEP <value>
[:SOURce]:FREQuency:STEP?
Description Set the RF output frequency step.
Query the RF output frequency step.
Parameter Name Type Range Default
<value> Real 10mHz to 1GHz 100MHz
Explanation  When <value> is set in "Number" form, the default unit is Hz, for example,
3000. In addition, <value> can also be set in "Number + Unit" form, for
example, 3kHz.
 The default unit of the return value is Hz.
 After the RF frequency step is set, you can use the up/down direction keys or
knob to modify the frequency at the current step. At this point, you can query
or set the frequency using the [:SOURce]:FREQuency command.
Return Format The query returns the RF frequency step, for example, 3000.
Example :FREQ:STEP 3kHz
:FREQ:STEP?
Related
Command
[:SOURce]:FREQuency