RIGOL DSG3000 Series - Manual (Page 35)

Chapter 2 Command System RIGOL
DSG3000 Programming Guide 2-15
:SOURce Commands
The :SOURce commands are used to set the related parameters of the main functions of the RF signal
generator including the frequency, level, phase, flatness, AM, FM/ØM, Pulse, SWEEP, LF output and so on.
Command List:
 [:SOURce]:AM Command Subsystem
 [:SOURce]:CORRection Command Subsystem
 [:SOURce]:FM Command Subsystem
 [:SOURce]:FMPM:TYPE
 [:SOURce]:FREQuency Command Subsystem
 [:SOURce]:INPut:TRIGger:SLOPe
 [:SOURce]:IQ Command Subsystem
 [:SOURce]:LEVel Command Subsystem
 [:SOURce]:LFOutput Command Subsystem
 [:SOURce]:MODulation:STATe
 [:SOURce]:PHASe Command Subsystem
 [:SOURce]:PM Command Subsystem
 [:SOURce]:PULM Command Subsystem
 [:SOURce]:SWEep Command Subsystem
[:SOURce]:AM Command Subsystem
Command List:
 [:SOURce]:AM:DEPTh
 [:SOURce]:AM:DEPTh:STEP[:INCRement]
 [:SOURce]:AM:FREQuency
 [:SOURce]:AM:FREQuency:STEP[:INCRement]
 [:SOURce]:AM:SOURce
 [:SOURce]:AM:STATe
 [:SOURce]:AM:WAVEform