Fujitronic Programmable Operation Display UG520H-x - Manual (Page 107)

2 - 38
Port 0
19200bps
Even
7 (ASCII)
ON for RS-422
Baud Rate
Parity
Transmission
Code
Data Length
Stop Bit 2
Synchronizing Switch
CTS Switch
5V Supply Switch
Terminal Resistor
Item Setting of PLC
0
19200bps
Even
7
2
Command Level
1:1/1:n Protocol
Comm. Parameter of POD
3 (fixed)
1 : n (fixed)
Internal Synchronization (fixed)
0V (normally ON) (fixed)
OFF (fixed)
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
* For the SYSMAC- Series and COM1 Series, set “0001” into DM6645 and “0304” (HEX) into DD6646 on
the RS-232C port at the CPU side to use the recommended communication settings indicated in the table
above.
For the CS1 Series, store the values which match the communication setting in D32000 (D32010) and the
following when the communication board is used for communication; in the memory space corresponding
to machine No. when the communication unit is used.
•
If [SYSMAC C] is selected at the [Select PLC Type] dialog, set the [Trans. Mode] for [Detail] in the
[Comm. Parameter] in UG00S-CW.
* 1 w/+/- sign BCD
It is possible to display the data for PLC data with signs + and -.
When higher 4 bits of the memory are [F or A], treat the data as the minus data.
[F] : regards higher 4 bits of the memory as [-0]
[A] : regards higher 4 bits of the memory as [-1]
•
range 1 word : -1999 to +9999
2 words : -19999999 to +99999999
<Ex.>
•
How to set : Num. Display
[Input Type] BCD
[Display Type] DEC(w/ -sign, w/ +sign)
13 OMRON PLC • 1
Trans. Mode Contents
Trans. Mode 1 w/o sign BCD
Trans. Mode 2 w/+/- sign BCD * 1
PLC memory Display of POD
0000 to 9999 0 to 9999
F001 to F999 -1 to -999
A000 to A999 -1000 to -1999
00000000 to 99999999 0 to 99999999
F0000001 to F9999999 -1 to -9999999
A0000000 to A9999999 -10000000 to -19999999