Fujitronic Programmable Operation Display UG520H-x - Manual (Page 218)

3 - 4
6.2 Max.
6.2 Max.
CN2
MJ1 MJ2
CN1
100- 240V AC
L
N NC
FG IN0 IN2 IN4 IN6 IN8 IN10 IN12 IN14 CO M+ OUT0
IN1 IN3 IN5 IN7 IN9 IN11 IN13 IN15
OUT2 OUT 4 OUT6 COM 1 OUT9 OUT 11 OUT13 OUT15
OUT1 OUT3 OUT 5 OUT7 OUT 8 OUT10 OUT 12 OUT14 COM2
DC24V
MJ1
POD
Fasten screws in
these two places. Serial expansion
I/O unit
Cable contained
in the package. Connect the cable
with MJ1 or MJ2.
Fasten screws in
these two places.
Mounting the serial expansion I/O unit
•
Mount the serial extension I/O unit, then secure
it using the four screws as shown in the figure on
the right.
•
Connect MJ1 on the serial expansion I/O unit
with MJ1 (MJ2) at the bottom of the POD using
the cable contained in the package.
Tightening the terminal screws on the terminal base
The following table shows the screw to be used and tightening torque:
Place Screw size Tightening torque (N•m) Crimp terminal (unit: mm)
Screw for I/O
terminal terbase M3 0.3 to 0.5
minal
2 Connecting the UG00P-U2
Specifications
Item Specifications
Rated voltage 24V DC
±
10%
Power supply Consumption current 60 mA max.
Inrush current 1.5 A (200 µ s) max.
Operating temperature 0 to +50 deg.C
Physical
Storage temperature -10 to +60 deg.C
environmental Operating humidity 20 to 85%; No condensation.
conditions
Dust Conductive dust.
Corrosive gus No corrosive gases.
Vibration resistance Vibration frequency: 10 to 150 Hz, Acceleration: 14.7 m/s 2 ,
Mechanical
Directions: X, Y, and Z. (Vibration was applied in each direction for
service one hour.)
conditions
Shock resistance Pulse wave: Half sine waves, Peak acceleration: 147 m/s 2 ,
Directions: X, Y, and Z. (Shock was applied in each direction twice.)
Electrical
Resistance to noise Noise voltage: 1,500V, Pulse width: 1
µ
s, Rising time: 1 ns.
service Withstand voltage Between power supply and FG terminal: 500V AC, 1 minute
conditions
Isolation resistance 500V DC, 10 M
Ω
or more
Ground Type II grounding
Mounting
Cooling method Natural air-cooling
conditions External dimensions 182 (188) 90 36
(W H D (mm))
Mounting dimensions 158 83
(W H (mm))
Case color Munsell 5Y3/0.5 (dark gray). The bottom plate is not colored.
Others Case material Steel plate
Mass 500g