Fujitronic Programmable Operation Display UG520H-x - Manual (Page 65)

1 - 56 17 Operation of POD Main Menu
5. Press the [Save] switch to save the setting data. (The setting data is written in the flash ROM.)
6. By doing this, screen adjustment is completed.
Notes on RGB input
When there is no RGB input (when the cable is not connected), the mode cannot be changed over to
RGB display mode.
When bit 12 of read area (n+1) is set to “1”, the mode is changed over to RGB display mode the
moment RGB input is restored (the moment the cable is connected).
Main Menu
RGB Adjust
Adjust Adjust
Clear Save
Horizontal : 31180 Hz Vertical : 59 Hz
Please refer to the manual, "Hardware".
Setting-1 Setting-2
Not used Not used