Fujitronic Programmable Operation Display UG520H-x - Manual (Page 128)

2 - 59
21
YOKOGAWA PLC • 2
( FA-M3 / FA-M3R )
Available PLC
* 1 CPU types which can be connected directly to programming tool port on a CPU module are
“F3SP21-0N,” “F3SP25-2N” and “F3SP35-5N.”
* 2 When the link unit, F3LC01-1N, is used, the communication setting and available memory are
the same as the contents of “20 YOKOGAWA PLC • 1(FA-500),” provided that B(common
register) cannot be used.
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
* When using programming tool port on a CPU module for direct connection to POD, set [Data
Length] as [8-bit] in the [comm. Parameter] dialog of POD because data length “8” is fixed. Also,
specify the “CPU Communication Port” setting of “Configuration” in the ladder making tool as
follows.
Personal Computer Link Function : Use
19200bps
Even
7
Provided
Baud Rate
Parity
Transmission
Code
Data Length
Stop Bit 1
Sumcheck
Terminal Character
Item Setting of PLC
19200bps
Even
7
1
Protection Function
Comm. Parameter of POD
Provided
None (fixed)
None (fixed)
*
FA-M3 FA-M3 F3LC01-1N
Programming tool port
on a CPU module
PLC Link Unit Wiring Diagram
RS-232C [Wiring Diagram 1]
Cable made by YOKOGAWA
[KM11-2N]
F3LC11-1N RS-232C [Wiring Diagram 1]
F3LC11-2N RS-422 [Wiring Diagram 2]
Select PLC Type
* 2
Programming tool port
on a CPU module Cable made by YOKOGAWA
[KM11-2N]
FA-M3 R FA-M3R
* 1
F3LC12-1F RS-232C [Wiring Diagram 1]
21 YOKOGAWA PLC • 2