Fujitronic Programmable Operation Display UG520H-x - Manual (Page 19)

1 - 10 3 System Composition
GD
G P P
UG03I-x [x:T T-Link, x:J OPCN-1, x:S SX BUS,
x:E(2) Ethernet•FL-net, x:C CC-Link,
x:P PROFIBUS] (Communication Interface Unit)
Used to communicate with each network.
It makes it possible to connect multiple UGx20 series to a PLC. This system,
which enables other devices to connect to the same network, brings about
the reduction in costs of the whole system.
UG02I-x
[x:T T LINK, x:J OPCN-1, x:S SX BUS]
(Communication Interface Unit)
Used for UG220 to communicate with each network.
UG00P-DI (ACPU/QnACPU/FXCPU Dual Port Inter-
face)
Add-on connector with two ports, specifically designed for the connector on
the MITSUBISHI’s ACPU/QnACPU/FXCPU programmer. This can improve
operability of the ACPU/QnACPU/FXCPU programmer that is directly
connected.
UGx20P-PS
[x:2 UG220,UG221 , 3 UG320 , 4 UG420,
5 UG520] (Protection Sheet)
Protects the operation panel surface. Five sheets are included in one
package.
UG00C-B (bar-code reader (temperature controller)
connecting cable) 3 m
Used to connect a bar-code reader to the POD.
Also used to connect a temperature controller to the POD via RS-232C.
UG00C-H (Multi-link 2 (temperature controller)
connecting cable) 3 m
Used to connect between POD master and POD slave for Multi-link 2
connection.
Also used to connect a temperature controller to the POD via RS-485.POD
slave station in the Multi-Link 2 connection.
UGxxP-Bx [UG220P/320P/420P/520P-Bx]
(Backlight for Replacement)
Placement backlight parts for UGx20 series.