Fujitronic Programmable Operation Display UG520H-x - Manual (Page 254)

3 - 40
20. Mount the 6 screws.
21. Mount the connector for the backlight unit (CFL unit).
22. Mount connector B.
23. Mount connector A.
Make sure that the connectors are correctly inserted in their original
places by using the marks made before removal.
24. Mount the 2 ribbon cables.
25. Mount the rear outside case on the front outside case.
*After fitting the rear outside case, firmly press the entire case body to fit the internal “POWER” board
connector into the CPU board connector.
26. Mount the 6 screws on the rear outside panel.
LCD module case
Front outside case
Screw
Screw
Ribbon cable
Connector for
backlight unit
(CFL unit) Connector A
Connector B
Connector for ribbon cable
Lock
Lock
Connector for ribbon cable
Ribbon cable
With the ribbon cable inserted in the connector, slide the lock to lock it.
Rear outside case
Screw
7 How to Replace the Backlight Unit