Fujitronic Programmable Operation Display UG520H-x - Manual (Page 58)

1 - 49
* In case of matrix type
When pressing the [Switch Check] switch, the following screen which is divided by a minimum size of
switch is displayed. Confirm that the color of the pressed switch changes into white. Pressing the
corner right below leads to the previous [I/O Test] screen.
If the pressed area is reversed, these
switches reacts to the touch normally.
D. Test of SYSTEM & Function Switches
Check the eight switches (six switches for UG221 and UG220) placed vertically on the right side of the
POD panel.
The test is OK if the lamps on the screen turn on when each switch is pressed.
E. Main Menu
Pressing this [Main Menu] switch leads to the previous [Main Menu].
SYS
F-1
F-2
F-3
F-4
F-5
F-6
F-7
SYS
F-1
F-2
F-3
F-5
F-6
F-7
F-4 The test is OK
when the [F-4] lamp is lit.
Press the [F4] switch.
SYS
F-1
F-2
Main Menu
Switch Check Check
Main Menu Main Menu
System Information System Information
Screen Data
Information
Screen Data
Information
Size : Size :
PLC Type: MITSUBISHIAnA/N/U series
Comment:
Error: Stop
Time-Out: 0.50 sec
Retry: 3
Connection: 1 : 1 Baud Rate: 19200
Signal Level: RS232C Data Length: 7
PLC Stat.No.: 0 Stop Bit: 1
Parity: Even
Send Delay: 0msec
SYSTEM PROG. VER.1.000
FONT
VER.1.000/1.000/1.000
JAPANESE 32 I/F DRV VER. 1.000
MELSEC AnA/N/U
1998- 9- 1 7 : 23 : 30
Editor : MJ1
Memory-Card I/O Test
UG420H-TC1M1
786432
Own Stat.No.: 1
V6 Total: 2
Retry: 10
Multi-Link Network Multi-Link Network
Press the [Main Menu] switch.
The "Main Menu" is displayed.
17 Operation of POD Main Menu
Main Menu SYS
F-1
F-2
Switch Check
Press
the [Switch Check] switch.
the [Switch Check] screen