Fujitronic Programmable Operation Display UG520H-x - Manual (Page 61)

1 - 52 17 Operation of POD Main Menu
Message Display in Data Transferring
If an error occurs during transferring data, the message
display window shown on the right is displayed. The kinds
and the contents of the messages are as shown below.
O K
Work nomally finished.
Message Contents
Work normally finished.
UG00P-MR not connecting
UG00P-MR Communication Error
Memory-Card not setting
Memory-Card Capacity over
Write Protect : ON
Writing Error occurred.
Selected data does not exist.
POD type is different.
Selected data can not be read.
Reading Error occurred.
Data discrepant
Screen data on POD will be broken.
Undefined Error occurred.
The specified operation has been concluded normally.
UG00P-MR is not connecting when selecting a modular jack.
A communication error occurred between POD and
UG00P-MR when selecting a modular jack.
A memory card is not inserted.
(Or in case of trying to write data into a memory card
when inserting FLASH ROM type memory card)
Cannot write the data into a memory card because
the data size in POD is larger than the capacity of
a memory card.
Cannot write data into a memory card because
the write protect switch in a memory card is ON.
The error occurred while writing data into a memory
card.
The data in the reading target does not exist.
The specified type of the data in POD is different from the
type of the memory card data.
The data in a memory card cannot be read.
The error occurred during writing data into a FLASH
ROM of POD.
There is some discrepancy in data, when comparing data
between a memory card and POD.
This message appears to inform the user that the data in
POD will be broken by transferring the font data (the size
which is larger than the present data) from a memory
card to POD. (The [OK] switch continues the transferring.
The [Cancel] switch stops transferring.)
The error occurred due to some cause other than
the above mentioned.