Fujitronic Programmable Operation Display UG520H-x - Manual (Page 81)

2 - 12
Wiring
•
Fully consider the influence of noise on the communication cable routed between the POD and FLEX-PC.
(The level of noise resistance when a ferrite core is attached to the cable: 1,000 V)
•
Fully consider the influence of noise on the cable when routing it on the board and in the unit. Route the
cable apart from the power lines.
•
The longer the communication cable, the more it is influenced by noise. Carefully route the cable.
When you create the cable, attach a ferrite core to reduce the influence of noise.
For a long distance communication, it is recommended to use link units in consideration of the noise
influence.
Dedicated Cable
Dedicated cables for direct connection with the N
Series loader port is available. The table on the
right shows the types of dedicated cables available.
Ferrite cores are already attached to all the dedi-
cated cables.
Connected to the loader port
N Series PC
Attach a ferrite core.
Attach it close to the connector.
Two ferrite core are respectively attached to the POD end and PLC end.
Maker : TDK
Type : ZCAT0930
Type Details
UG200C-N02 For direct connection with loader port : 2 m
UG200C-N03 For direct connection with loader port : 3 m
UG200C-N05 For direct connection with loader port : 5 m
5 FUJI PLC • 5