Fujitronic Programmable Operation Display UG520H-x - Manual (Page 221)

3 - 7 3 Connecting the Memory Card Recorder
Screw * 1
* 1 : Use M3-size screws.
Cover panel (side)
Attachment cover
Attachment cover
Cover panel (side)
Screw
Screw
Cover panel (side)
Attachment cover
UG00P-MR, body
55.5mm
Attachment cover
Cover panel (side)
Screw
Secure the body by
screwing every side.
Assembling the Recorder
1 Cut the cover panel (maximum thickness: 5 mm) so that the attachment cover can be set, then insert the
attachment cover into the cover panel.
2 Secure the attachment cover to the cover panel using the screws.
3 Insert the UG00P-MR into the attachment cover, then secure it using four screws.
•
See the table below for how to tighten
the screw for fixing a unit:
Screw type Screw size Tightening
torque(N•m)
Screw for securing M3 0.3 to 0.5
a unit