Fujitronic Programmable Operation Display UG520H-x - Manual (Page 80)

2 - 11 4 FUJI PLC • 5
FUJI PLC • 5
(FLEX-PC CPU port)
5
Available PLC
* 1 When FLEX-PC CPU TOYOTA version is used, select “FLEX-PC CPU(T)” in [PLC Type].
When the CPU is updated, or the specifications are changed, there is some possibility that
POD cannot be connected to the PLC.
Communication Setting
Connect to the CPU port. The communication parameter setting of POD is done automatically.
When you use the RS-232C port of NJ-CPU-B16, be sure to set above items using the [Comm.
Parameter ] dialog on the PLC side.
Available Memory
* The current values of the timer and counter are indicated with TN/CN for purposes of
convenience in the table above. (The actual value is T/C.)
Set the memory to the extent of the memory range of each PLC model.
Use TYPE number to assign indirect memory for macro programs.
RS-422 [UG200C-N] FLEX-PC Loader Port
PLC Select PLC Type
FLEX-PC
CPU NJ-B16 RS-232C Port RS-232C [Wiring Diagram 1]
* 1
Wiring Diagram
19200bps
RS-422
Aneven Aneven
RS-422 Transmission
Control Mode
Baud Rate
Parity
Data Length
Stop Bit
Item
19200bps
8 8
1 1
Transmission
Code
Comm. Parameter of POD
Loader Port
NJ-B16RS-232C Port RS-232C RS-232C
Setting of PLC (All fixed)
Standard Memory TOYOTA Ver. TYPE Remarks
D (data register) D 0
W (link register) R 1
M (internal relay) M 2 WM as word device
L (latch relay) K 3 WL(WK) as word device
X (input relay) X 4 WX as word device
Y (output relay) Y 5 WY as word device
R (file register) W 6
TN (timer/current value) TN 7 *
CN (counter/current value) CN 8 *
T (timer/contact) T 9
C (counter/contact) C 10
WS (step relay) - 11