Fujitronic Programmable Operation Display UG520H-x - Manual (Page 176)

2 - 107
KEYENCE PLC • 1
(KZ series link)
40
Available PLC
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
For further information, refer to the communication specifications of KEYENCE link unit.
Set the port with the port setting switch, the terminating resistance with
terminator, and the baud rate/data bit/parity/stop bit with SET B dip switches.
Available Memory
Set the memory to the extent of the memory range of each PLC model.
Use TYPE number to assign indirect memory for macro programs.
PLC
KZ300
KZ350
Port 2
RS-232C [Wiring Diagram 2]
RS-422 [Wiring Diagram 3] KZ-L2
Port 1
RS-232C [Wiring Diagram 1]
Select PLC Type
KZ
Series link
Link Unit Wiring Diagram
19200bps
Even
7 (ASCII)
ON for RS-422
Baud Rate
Parity
Transmission
Code
Data Length
Stop Bit 2
Terminal Resistor
Item Setting of PLC
19200bps
0 Port 0
Even
7
2
Comm. Parameter of POD
40 KEYENCE PLC • 1
Memory TYPE Remarks
DM (data memory) 0
CH (input/output relay) 1