Fujitronic Programmable Operation Display UG520H-x - Manual (Page 236)

3 - 22
10. Remove the 4 screws fixing the LCD module.
11. Remove the LCD module from the inside case.
LCD module
Screws
12. Place the LCD module with the display panel side down.
Place it on a cloth, etc. to protect the display panel from scratches.
13. Partly remove the cushioning material.
* The cushioning material is cemented with an adhesive. Remove only the portion on the backlight unit
(CFL unit) cover.
14. Remove the screw fixing the backlight unit (CFL unit) cover.
* Since the screw is small, use a precision screwdriver to remove it.
15. Use a precision screwdriver, slide the cover in the direction of arrow (1), and remove the cover from the
claws while pulling it up in a slanting direction (as shown with the arrow (2)).
Cover
LCD module (rear)
(1)
(2)
Cover fixing screw
Cushioning material
Inside case
7 How to Replace the Backlight Unit