Fujitronic Programmable Operation Display UG520H-x - Manual (Page 73)

2 - 4
FUJI PLC • 2
(MICREX-SX series)
Available PLC
* Only one unit of POD can be connected to one link unit, except for “Multi-link 2” connection.
Communication Setting
The recommended communication parameter setting of both PLC and POD is as follows:
* No function block (FB) settings are required on the PLC.
Available Memory
To specify a memory, basically a variable name is set. For the variable name linkage function, refer to the
User’s Manual <Variable Name Cooperation Function> (FEH363).
Set the memory to the extent of the memory range of each PLC model.
Use TYPE number to assign indirect memory for macro programs.
To set an indirect memory using a macro, specify the CPU No. using the extended code.
Indirect memory setting by macro is not available for input (I) or output (Q) memory.
2
PLC
NP1L-RS2
NP1L-RS4
NP1L-RS1
RS-232C [Wiring Diagram 1]
RS-485 [Wiring Diagram 2]
RS-232C [Wiring Diagram 1]
RS-485 [Wiring Diagram 2]
Select PLC Type
MICREX-SX
Series
SPH Series
(NP1PS- x )
Wiring Diagram Link Unit
Transmission
Control Mode RS-232C
RS-422
Baud Rate
Parity
Data Length
Stop Bit
Item Setting of PLC
RS-232C
RS-422 Mode 2
Mode 1
Comm. Parameter of POD
1 (fixed)
8 (fixed)
Even (fixed)
38400bps (fixed)
1 FUJI PLC • 2
Standard Memory TYPE Remarks
I (input memory) -
O (output memory) -
M (standard memory) 2
RM (retain memory) 4
SM (system memory) 8