Fujitronic Programmable Operation Display UG520H-x - Manual (Page 251)

3 - 37
6. Remove the two ribbon cables.
* The connector cannot be removed.
7. Remove the 6 screws that fix
the inside case.
8. Remove the inside case from
the front outside case.
9. Put the inside case on the table, with the display panel up.
10. Remove the 4 screws that fix the LCD module.
11. Remove the LCD module from the inside case.
12. Put the LCD module on the table, with the display panel down.
Put a cloth or other protective material under the product so as not to
damage the display panel.
Inside case
Front outside case
Screw
Screw
Ribbon cable
Connector for ribbon cable
Lock
Lock Connector for ribbon cable
Slide the lock to unlock it.
Ribbon cable
LCD module
Inside case
Screw
7 How to Replace the Backlight Unit