Fujitronic Programmable Operation Display UG520H-x - Manual (Page 53)

1 - 44
A
B
C
E
D Press the [I/O Test] switch.
Memory-Card I/O Test
SYS
F-1
F-2
F-3
F-4
F-5
F-6
F-7
Self-Loop Test
CTS
NG OK
RTS
CN1 RS-232C
MJ1 RS-485
MJ2
Communication Port
Main Menu
I/O Test
Switch Check Printer Check
Please refer to the manual, "Hardware Specifications".
Self-Loop Test Self-Loop Test
I/O Test
When the switch “a” on the “Main Menu” is pressed, the following “I/O Test” is displayed.
This is the test menu to check only POD hardware.
I/O Test
Self-Loop
Test
Communication Port
RTS CTS
NG OK
CN1
MJ1
RS232C
RS485
MJ2
SYS
F-1
F-2
F-3
F-4
F-5
Main Menu
Printer Check
Switch Check Serial Test
C
E D
B
A
Press the "I/O Test" switch.
1 2 : 2 4 : 3 0
I / O T e s t
C o m m u n i c a t i o n
P a r a m e t e r
M e m o r y
- C a r d
I/O Test I/O Test
P l e a s e r e f e r t o t h e m a n u a l ,
" H a r d w a r e S p e c i f i c a t i o n s " .
Press the "Serial Test" switch.
Serial Test Serial Test
Self-Loop Test Self-Loop Test
* In case of UG221 and UG220, when the switch “A” on the “Main Menu” is pressed, the following “I/O
Test” is displayed.
Then, the “Serial Test” switch on the “I/O Test” is pressed. The following “Serial Test” is displayed.
The self-loop test can be executed on this screen.
17 Operation of POD Main Menu