Fujitronic Programmable Operation Display UG520H-x - Manual (Page 51)

1 - 42
Operation of POD Main Menu
17
"Main Menu" after trasferring data When power is turned on for the first time:
Main Menu Main Menu
System Information System Information
Screen Data
Information
Screen Data
Information
Size : Size :
PLC Type: MITSUBISHIAnA/N/U series
Comment:
Error: Stop
Time-Out: 0.50 sec
Retry: 3
Connection: 1 : 1 Baud Rate: 19200
Signal Level: RS232C Data Length: 7
PLC Stat.No.: 0 Stop Bit: 1
Parity: Even
Send Delay: 0msec
SYSTEM PROG. VER.1.000
FONT
VER.1.000/1.000/1.000
JAPANESE 32 I/F DRV VER. 1.000
MELSEC AnA/N/U
1998- 9- 1 07 : 23 : 30
Editor : MJ1
Memory-Card I/O Test
UG420H-TC1M1
786432
When the power of POD is turned on for the first time, the screen on the below left is displayed. After
transferring the screen data to POD, the following “Main Menu” is displayed.
S
Y
S
T
E
M
M
O
D
E
the [SYSTEM] switch the [F1] switch
The "Main Menu" is displayed.
S
Y
S
T
E
M
M
O
D
E
Main Menu Main Menu
System Information System Information
Screen Data
Information
Screen Data
Information
Size : Size :
PLC Type: MITSUBISHIAnA/N/U series
Comment:
Error: Stop
Time-Out: 0.50 sec
Retry: 3
Connection: 1 : 1 Baud Rate: 19200
Signal Level: RS232C Data Length: 7
PLC Stat.No.: 0 Stop Bit: 1
Parity: Even
Send Delay: 0msec
SYSTEM PROG. VER.1.000
FONT
VER.1.000/1.000/1.000
JAPANESE 32 I/F DRV VER. 1.000
MELSEC AnA/N/U
1998- 9- 1 07 : 23 : 30
Editor : MJ1
Memory-Card I/O Test
UG420H-TC1M1
786432
* The switches that are displayed on the [Main Menu] screen changes
with the option provided from the manufacturer, the communication
I/F unit installed, or the screen setting (temperature controller, etc.)
If the screen data has been already transferred to POD, press the [SYSTEM] switch, then press the [F1]
switch. The [Main Menu] is displayed.
Main Menu
The “Main Menu” is the system menu for transferring the data between a personal computer and POD.
When the screen data is transferred from a personal computer to POD, the “Main Menu” must be displayed.
(If [Editor port] is selected for [Modular Jack 1] in the [P2] menu of the editing software or the on-line editing is
executed, it is not necessary to display the “Main Menu”.
17 Operation of POD Main Menu