MITSUBISHI ELECTRIC MR-E- A/AG - Manual (Page 120)

6 - 5
6. DISPLAY AND OPERATION
6.3 Diagnostic mode
Name Display Description
Not ready.
Indicates that the servo amplifier is being initialized or an alarm
has occurred.
Sequence
Ready.
Indicates that the servo was switched on after completion of
initialization and the servo amplifier is ready to operate.
External I/O signal
display
Refer to section 6.6. Indicates the ON-OFF states of the external I/O signals.
The upper segments correspond to the input signals and the
lower segments to the output signals.
Lit: ON
Extinguished: OFF
The I/O signals can be changed using parameters No. 43 to 49.
Output signal (DO)
forced output The digital output signal can be forced on/off. For more
information, refer to section 6.7.
Jog feed
Jog operation can be performed when there is no command from
the external command device.
For details, refer to section 6.8.2.
Positioning
operation
The servo configuration software (MRZJW3-SETUP154E) is
required for positioning operation. This operation cannot be
performed from the operation section of the servo amplifier.
Positioning operation can be performed once when there is no
command from the external command device.
Motorless
operation
Without connection of the servo motor, the servo amplifier
provides output signals and displays the status as if the servo
motor is running actually in response to the external input
signal.
For details, refer to section 6.8.4.
Test
operation
mode
Machine
analyzer
operation
Merely connecting the servo amplifier allows the resonance point
of the mechanical system to be measured.
The servo configuration software (MRZJW3-SETUP154E or later)
is required for machine analyzer operation.
Software version low Indicates the version of the software.
Software version high Indicates the system number of the software.
Manufacturer setting
screen
Screen for manufacturer setting. When this screen is being
displayed, do not press any other buttons than "UP" and "DOWN"
button.
Motor series
Press the "SET" button to show the motor series ID of the servo
motor currently connected.
Motor type
Press the "SET" button to show the motor type ID of the servo
motor currently connected.
Encoder
Press the "SET" button to show the encoder ID of the servo motor
currently connected.