MITSUBISHI ELECTRIC MR-E- A/AG - Manual (Page 289)

15 - 44
15. MR-E- AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
Class No. Symbol Name and function
Initial
value
Unit
Setting
range
Control
mode
44 *DI3 Input signal selection 3 (CN1-3)
Allows any input signal to be assigned to CN1-pin 3.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
Speed
control mode
Input signals of
CN1-pin 3
selected.
Torque
control mode
0 2
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 3.
If forward rotation stroke end (LSP) or reverse rotation stroke end
(LSN) is assigned to pin 3 of CN1 with parameter No. 48, this
parameter cannot be used.
0882 Refer to
Name
and
function
column. S T
45 *DI4 Input signal selection 4 (CN1-5)
Allows any input signal to be assigned to CN1-pin 5.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
Speed
control mode
Input signals of
CN1-pin 5
selected.
Torque
control mode
0 5
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 5.
If forward stroke end (LSP) or reverse rotation stroke end (LSN) is
assigned to pin 5 of CN1 with parameter No. 48, this parameter
cannot be used.
0995 Refer to
Name
and
function
column. S T
Ex
pan
si
on
par
ame
te
rs
1
46 *DI5 Input signal selection 5 (CN1-6)
Allows any input signal to be assigned to CN1-pin 6.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
Speed
control mode
Input signals of
CN1-pin 6
selected.
Torque
control mode
0 0
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 6.
If reverse rotation stroke end (LSN) is assigned to pin 6 of CN1 with
parameter No. 48, this parameter cannot be used.
0000 Refer to
Name
and
function
column. S T