MITSUBISHI ELECTRIC MR-E- A/AG - Manual (Page 75)

3 - 44
3. SIGNALS AND WIRING
3.10 Grounding
WARNING
Ground the servo amplifier and servo motor securely.
To prevent an electric shock, always connect the protective earth (PE) terminal of
the servo amplifier with the protective earth (PE) of the control box.
The servo amplifier switches the power transistor on-off to supply power to the servo motor. Depending on
the wiring and ground cablerouting, the servo amplifier may be affected by the switching noise (due to
di/dt and dv/dt) of the transistor. To prevent such a fault, refer to the following diagram and always
ground.
To conform to the EMC Directive, refer to the EMC Installation Guidelines (IB(NA)67310).
Control box
Servo amplifier
L 1
L 2
L 3
CN1
L
ine
f
ilt
er
NFB MC
Protective earth(PE)
CN2
U
V
W
Outer
box
Servo motor
Ensure to connect it to PE
terminal of the servo amplifier.
Do not connect it directly to
the protective earth of
the control panel.
Encoder
SM
U
V
W
(Note)
Power supply
3-phase
200 to 230VAC,
1-phase
230VAC
Note: For 1-phase 230VAC, connect the power supply to L 1 L 2 and leave L 3 open.
P
rogra
m
m
abl
e
cont
ro
ller