MITSUBISHI ELECTRIC MR-E- A/AG - Manual (Page 25)

1 - 8
1. FUNCTIONS AND CONFIGURATION
(2) MR-E-200A
Refer to Name/Application
Chapter6
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
MODE UP DOWN SET
Operation section
Used to perform status display, diagnostic, alarm and
parameter setting operations.
Chapter6
Communication connector (CN3)
Used to connect a command device (RS232C)
and output analog monitor data.
Section3.3
Section13.1.2
Chapter14
I/O signal connector (CN1)
Used to connect digital I/O signals.
Section3.3
Name plate
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Section1.5
Section3.3
Section13.1.2
Motor power supply connector (CNP2)
Used to connect the servo motor.
Protective earth (PE) terminal ( )
Ground terminal.
Power supply/regenerative connector (CNP1)
Used to connect the input power supply and
regenerative brake option.
Section3.7
Section11.1
Section3.7
Section11.1
Section13.1.1
Section3.10
Section11.1
Cooling fan
Installation notch
(4 places)