NEC PD750008 - Manual (Page 157)

137
CHAPTER 5 PERIPHERAL HARDWARE FUNCTIONS
5.6.5 Three-Wire Serial I/O Mode Operations
The three-wire serial I/O mode is compatible with other modes used in the 75 XL series, 75X series,
µPD7500 series, and 87AD series.
Communication is performed using three lines:
Serial clock (SCK), serial output (SO), and serial input (SI).
Figure 5-43. Example of Three-Wire Serial I/O System Configuration
Remark The µPD750008 can also be used as a slave CPU.
(1) Register setting
To set the three-wire serial I/O mode, manipulate the following two registers:
• Serial operation mode register (CSIM)
• Serial bus interface control register (SBIC)
(a) Serial operation mode register (CSIM)
To use the three-wire serial I/O mode, set CSIM as shown below. (For details on CSIM format, see
(1) in Section 5.6.3.)
CSIM0 is manipulated using an 8-bit manipulation instruction. Bits 7, 6, and 5 of CSIM can be
manipulated bit by bit.
When the RESET signal is input, CSIM is set to 00H.
In the figure below, hatched portions indicate the bits used in the three-wire serial I/O mode.
Remark (R): Read only
(W): Write only
SCK
Master CPU
µPD750008
SO
SI
Slave CPU
SCK
SI
SO
3-wire serial I/O 3-wire serial I/O
CSIE COI WUP CSIM4 CSIM3 CSIM2 CSIM1 CSIM0
FE0H
CSIM
7 6 5 4 3 2 1 0
Address
Serial clock selection bit (W)
Serial interface operation mode selection bit (W)
Wake-up function specification bit (W)
Match signal from address comparator (R)
Serial interface operation enable/disable specification bit (W)