NEC PD750008 - Manual (Page 322)

302
µPD750008 USER'S MANUAL
PROM programming tools
Note These software products cannot use the task swap function, which is available in MS-DOS Ver. 5.00
or later.
Remark Operation of the PG-1500 controller is guaranteed only on the above host machines and OSs.
Hardware
Software
Distribution media
3.5-inch 2HD
5.25-inch 2HD
3.5-inch 2HD
5.25-inch 2HC
OS
MS-DOS
Ver. 3.30
to
Ver. 6.2 Note
See "OS for IBM
PC."
PG-1500
PA-75P008CU
PG-1500
controller
Part number
µS5A13PG1500
µS5A10PG1500
µS7B13PG1500
µS7B10PG1500
The PG-1500 PROM programmer is used together with an accessory board and optional
program adapter. It allows the user to program a single chip microcomputer containing
PROM from a standalone terminal or a host machine. The PG-1500 can be used to
program typical 256K-bit to 4M-bit PROMs.
The PA-75P008CU is a PROM programmer adapter provided for the µPD75P008CU/
GB and µPD75P0016CU/GB. It is used in conjunction with the PG-1500.
This program enables the host machine to control the PG-1500 through the serial and
parallel interfaces.
Host machine
PC-9800 series
IBM PC/AT and
compatibles
*